Check the box next to each Yealink phone you are assigning. Select the extension you would like to assign to the Yealink phone(s) from the drop down list.Ģ. Click the “Auto-Discovery” tab at the top, and then click “Auto-Discovery (scan network)”ġ. SAVE CHANGES then APPLY CHANGES.Īuto Discovery - If the phones are on the same LAN as the PBX you can use Auto Discovery. YEALINK FORGOT ADMIN PASSWORD FACTORY RESET MANUALManual – Navigate to Destinations -> Extensions -> Edit Extension -> Advanced and enter the MAC address of the phone into the “Phone MAC:” field. You must assign a phone to an extension either manually or using Auto-Discovery: If it is running, it will say "Listening" on that page. You can restart it by going to the commands tab and hitting start, if it has stopped. The Yealink discovery function will run for about 10 minutes before shutting itself back off. Phones that have been previously provisioned will NOT respond to configure or restart commands from this process. This only works for FACTORY DEFAULTED Yealink phones. Starting in version 6.0.5, we have added the ability to configure and restart Yealink phones from the autodiscovery section of the pbx, eliminating much of the process previously needed to set these phones up.ġ) Under Destinations=>Autodiscovery, after scanning the network, go to the commands tab and click the Yealink Detect link:ģ) In the list of phones discovered, you can now check the boxes, and assign, configure, and restart them as if they were IPitomy HD phones, using the buttons at the top of the page.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |